Home / Fittings / Quick-Connect Fittings / John Guest Bent Tap Connector - 15mm x 1/2 BSP
John Guest

John Guest Bent Tap Connector - 15mm x 1/2 BSP

Part Number: PEMBTC1514
Your price:
The John Guest Speedfit Bent Tap Connector easily connects to a tap connection with horizontal feeds. The bent tap connector push-fit fitting is used for the connection of plastic or copper pipes to fixtures or appliances with a MBSP connection point (horizontal pipe runs). The tap connector comes complete with brass swivel nut and sealing washer. Simply push the push-fit fitting fully onto the pipe and hand turn onto the thread. To disconnect, push the collet towards the body of the push-fit fitting and pull the pipe to release. The bent tap connector is up to 40% faster to install than traditional methods and is easier to use in confined spaces by removing the need for hot works and tools.

Features:
  • Instant push-fit connection
  • Install and uninstall in seconds without tools
  • Safe flame-free installation, with no hot works, glue or flux
  • Grip & Seal collet with stainless steel teeth and main O-Ring seal
  • Twist & Lock mechanism secures fitting and adds compression
  • Non-toxic, resists corrosion and no scale build-up
  • Compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe
  • Suitable for hot and cold water and central heating systems
  • EPDM O-Ring
  • Requires Pipe Insert or Superseal Pipe Insert to prevents over constriction of pipe from compression fittings


Application Usual working Temperature Maximum working Temperature Maximum Working Pressure, bar
Cold water (indirect & direct mains) 68° F 68° F 12
Central Heating 180° F 220° F 3
Hot water (including unvented cylinders) 149° F 203° F 6

 

California residents Prop 65 Warning
WARNING!
This product contains materials known to the State of California to cause cancer and birth defects or other reproductive harm. www.p65warnings.ca.gov