HM Digital PS-202 Dual Display TDS Controller

Install the Dual Display TDS Controller to constantly monitor TDS levels of water produced by a high-output system and immediately know if the TDS levels rise above an acceptable level. The Dual Display allows you to compare both measurements with just a quick glance and adjust the calibration to your needs.

Features:

Simultaneously monitors and controls the TDS levels of two water lines (e.g., the feed water and product water) for high output commercial systems
Large, bright L.E.D. display
An alarm will sound if the TDS level rises above the user-set level for both lines
Installs easily in minutes
Includes two sensor probes

California residents Prop 65 Warning

WARNING!

This product contains materials known to the State of California to cause cancer and birth defects or other reproductive harm. www.p65warnings.ca.gov

Product Details
Accuracy	±2 %
Alarm	Steady beep for both lines
Features	Auto Temp Control (1 - 65°C) Bright 5/8" L.E.D. dual displays
Measurement Range	0-999 ppm
Power Source	AC 110V / AC 220V
Probe	1/2" bushing, 3 meter (9.8 ft) shielded cable
Relay Control	The unit will open or close a circuit via dry contacts when the ppm level of the output water or input water reaches or exceeds its control setting. The PS-202 can be used to control one or two pumps, solenoid valves or other device.
Relay Voltage	5V
Resolution	1 ppm
Setting	Controlled by on-screen up/down buttons
Warranty & Certifications
Warranty	1 Year
Shipping Dimensions
Shipping Length	13 in.
Shipping Width	10 in.
Shipping Height	7 in.
Product Weight & Dimensions
Approx Depth	4.9"
Product Height	3.7"
Product Width	3.7"
Product Weight (lbs)	3.25